my account   cart contents   checkout
**Voodoo Lab**
Pedal Power 2 Plus  -  212.14EUR

Pedal Power 2 Plus
Specs. Output DIP Switch: Normal

Pedal Power 2 Plus

    1-4 9VDC 100mA (ACA)
    5-6 9VDC 250mA (L6)
    7-8 9VDC 100mA (SAG)

Specs. Output DIP Switch: ON

    1-4 12.3VDC 60mA (ACA)
    5-6 14.5V/12VDC unregulated 50mA/200mA+ (L6)
    7-8 Adjustable 4VDC-9VDC 100mA (SAG)

Isolation is more than fixing ground loops. Ground loops cause hum, and the solution is to break the unwanted ground path. Isolation is the best way to do it. Unlike other power supplies, Pedal Power 2 Plus isolates EVERY output. This eliminates tone robbing interaction between units. Now you can properly power everything from vintage overdrives to modern digital marvels!

Proprietary balanced transformer makes it possible. A typical transformer, like those used in a wall wart, creates a large magnetic field that causes hum in any audio path near it. Pedal Power 2 Plus uses a custom designed, ultra-low noise toroidal transformer, with separate balanced windings for every output. Now even the most sensitive pedals can be dead quiet.

Switching power supplies arent for everything. Whats good for charging a cell phone is NOT good for your pedals. While digital switching power supplies are small and inexpensive, they also generate unpredictable transients and extraneous noise. Pedal Power 2 Plus uses an audiophile quality linear supply for consistently stable, clean, pure power.

Short Circuit Protection. Each output on the Pedal Power 2 Plus is short-circuit protected. This means that if you have a short in a power cable, or one of your pedals malfunctions, PP 2 Plus will temporarily turn off the power to that pedal. All other outputs will continue to function normally with no long-term damage.

  • 9/12V (x4) Standard 9V and 12V Boss ACA With each one of these four outputs delivering 100mA, you can easily power any 9V battery-operated pedals. Boss pedals that specify the PSA adapter operate at 9V like most other pedals. Boss pedals that require the ACA adapter operate at 12V which can be selected via switches underneath the Pedal Power 2 Plus. Any one of these outputs can be individually selected to run at 9V or 12V.

  • 9V (x2) High Current 9V and Line 6 Modelers These two outputs each deliver 250mA allowing you run high current draw effects like the Boss DD-20 Giga Delay or Line 6 DL4 Delay Modeler. Via switches underneath the Pedal Power 2 Plus, these two outputs can be separately configured for regulated (Boss Twin Pedals) or unregulated (Line 6 Modelers) power allowing you to run both units if so desired. These outputs can also power any standard 9V effects as well.

  • 9V (x2) Standard 9V With Battery Sag Control These outputs each have an available 100mA of power, but also allow you to SAG the voltage from roughly 4V to 9V. This feature can be enabled via the bottom panel switches. The SAG control is mostly useful for transistor-based fuzz, octavia, and distortion circuits, as most modern opamp designs are minimally affected by variations in supply voltage. We recommend turning SAG off if youre going to run digital pedals like delay, chorus, and reverb.

  • 18V/24V Using Custom Cables All of the outputs on the Pedal Power 2 Plus (and the original Pedal Power) are completely isolated allowing you to create different voltages. You can run effects like the current MXR Flanger by combining two 9V outputs to create a single 18V supply. By switching two outputs into 12V ACA mode, you can join them together to create a 24V output for powering numerous Electro-Harmonix stompboxes including the Deluxe Memory Man.

  • Included Cables:
      6 pc. 5.5 x 2.1mm right angle barrel connectors
      2 pc. 5.5 x 2.1mm straight barrel connectors
      1 pc. 5.5 x 2.5mm Red barrel for L6
      1 pc. 3.5mm mini plug for vintage Maxon, TS-808, MXR or Electro-Harmonix
      1 pc. 9V battery snap for pedals without a power jack

    Dim. wide 152 x deep 86 deep x tall 45mm. - Weight: 0.9 kg - Warranty 5 years.

     Add to Cart 
     Add to Cart 

    2013 copyright pedaler   phone +45 4020 9006   phone +45 4363 7491   mail info@pedaler.eu
    Other Voodoo Lab products

    Shopping Cart more
    0 items

    Write ReviewWrite a review on this product!

    What's New?

    BB preamp
    BB preamp

    Phone +45 40209006
    Phone +45 Hendrix 1
    Mail info@pedaler.eu
    VAT DK  29 96 49 20
    Terms of Trade